Lighting Third Brake Light
What's so special about this circuit? Well, the first third-brake light I installed I had to pull a wire from the Third Brake Light all the way to the brake pedal switch and I thought it would be easier to pluck the signal of both brakelights via the trunk. Bench-test your circuit first and apply power to the circuit, with the brakelight connected, for at least a couple of minutes. If the two SCR's are getting hot (depending on the type of bulb in your 3rd brake light), mount coolribs on them. I used the NTE5483 which is a 8A, 200Vrm type.
Title: Lighting Third Brake Light
electronic circuit
Source: http://www.uoguelph.ca/~antoon
Published on: 2005-08-15
Reads: 1076
Print version: 
Other electronic circuits and schematics from Automotive
-
Car Battery Charger
-
Nite Rider Lights
-
Headlights Timer
-
Park-Aid
-
Simple but reliable car battery tester
-
Dome light dimmer for Cars
-
Wiper Speed Control
-
Car Alarm Arming Horn Beep Canceller
-
Speed-limit Alert
-
Charge Monitor for 12V lead acid battery