Simple but reliable car battery tester
This circuit uses the popular and easy to find LM3914 IC. This IC is very simple
to drive, needs no voltage regulators (it has a built in voltage regulator) and
can be powered from almost every source.
This circuit is very easy to explain:
When the test button is pressed, the Car battery voltage is feed into a high impedance
voltage divider. His purpose is to divide 12V to 1,25V (or lower values to lower
values). This solution is better than letting the internal voltage regulator set
the 12V sample voltage to be feed into the internal voltage divider simply because
it cannot regulate 12V when the voltage drops lower (linear regulators only step
down). Simply wiring with no adjust, the regulator provides stable 1,25V which is
fed into the precision internal resistor cascade to generate sample voltages for
the internal comparators. Anyway the default setting let you to measure voltages
between 8 and 12V but you can measure even from 0V to 12V setting the offset trimmer
to 0 (but i think that under 9 volt your car would not start). There is a smoothing
capacitor (4700uF 16V) it is used to adsorb EMF noise produced from the ignition
coil if you are measuring the battery during the engine working. Diesel engines
would not need it, but i'm not sure. If you like more a point graph rather than
a bar graph simply disconnect pin 9 on the IC (MODE) from power. The calculations
are simple (default)
For the first comparator the voltage is : 0,833 V corresponding to 8 V
* * * * * voltage is : 0,875 V corresponding to 8,4 V
...
..
for the last comparator the voltage is : 1,25 V corresponding to 12 V
Have fun, learn and don't let you car battery discharge... ;-)
Title: Simple but reliable car battery tester
electronic circuit
Source: www.electronics-lab.com
Published on: 2005-02-02
Reads: 2035
Print version:
Other electronic circuits and schematics from Automotive
-
Car Battery Charger
-
Pulsing Third Brake Light
-
Charge Monitor for 12V lead acid battery
-
Intermittent wiper controller
-
Nite Rider Lights
-
Headlight Flasher
-
Ultrasonic Parking Sonar
-
Synchronized multi-spark module (SMSM) for Electronic Ignition Devices (EID)
-
Automatic Headlight Brightness Switch
-
Headlights Timer