TV remote control Blocker
Just point this small device at the TV and the remote gets jammed . The circuit is self explanatory . 555 is wired as an astable multivibrator for a frequency of nearly 38 kHz. This is the frequency at which most of the modern TVs receive the IR beam . The transistor acts as a current source supplying roughly 25mA to the infra red LEDs. To increase the range of the circuit simply decrease the value of the 180 ohm resistor to not less than 100 ohm.
It is required to adjust the 10K potentiometer while pointing the device at your TV to block the IR rays from the remote. This can be done by trial and error until the remote no longer responds.
Title: TV remote control Blocker
electronic circuit
Source: www.electronic-circuits-diagrams.com
Published on: 2005-02-01
Reads: 2249
Print version: 
Other electronic circuits and schematics from Games and entertainment
-
Game Show Indicator Lights (Who's First)
-
3V LED Chaser
-
Electronic Scoring Game
-
The flashing Heart
-
6V Ultra-Bright LED Chaser
-
The Millipede
-
JAM(Just A Minute) Circuit
-
Pinewood Derby Finish Line Lamps