Sound detector latch
Sound detector latch circuit
Parts:
U1 | NE555 timer IC |
R1 | 1k resistor |
R2 | 50k potentiometer |
C1 | 0.1uF ceramic capacitor |
C2 | 10uf tantalum capacitor |
All resistors are 5 or 10 percent tolerance, 1/4-watt all capacitors are 10 percent tolerance, rated 35 volts or higher.
When the 555 ic goes into timing mode (triggered by an output signal from the sound detector amplifier,) the timer's output (pin 3) is set into HIGH for a duration set by C2, and R2. adjusting R1 will adjust how long it listens, from 10 seconds all the way down to 2/10ths of a second. this could be used to listen for hand claps.
Title: Sound detector latch
electronic circuit
Source: unknown
Published on: 2012-09-20
Reads: 260
Print version:
Other electronic circuits and schematics from Audio
-
3 Channel Spectrum Analyzer
-
10W Audio Amplifier with Bass-boost
-
Surround Sound Decoder
-
18W Audio Amplifier
-
FET Audio Mixer
-
Three-Level Audio Power Indicator
-
Low cost intercom using transistors
-
200W audio amplifier
-
100W RMS Amplifier
-
Mini-box 2W Amplifier