3 Transistor Audio Amp (50 milliwatt)
Electronic Schematics > Audio > 3 Transistor Audio Amp (50 milliwatt)

Here is a little audio amplifier similar to what you might find in a small transistor radio. The input stage is biased so that the supply voltage is divided equally across the two complimentary output transistors which are slightly biased in conduction by the diodes between the bases. A 3.3 ohm resistor is used in series with the emitters of the output transistors to stabilize the bias current so it doesn't change much with temperature or with different transistors and diodes. As the bias current increases, the voltage between the emitter and base decreases, thus reducing the conduction. Input impedance is about 500 ohms and voltage gain is about 5 with an 8 ohm speaker attached. The voltage swing on the speaker is about 2 volts without distorting and power output is in the 50 milliwatt range. A higher supply voltage and the addition of heat sinks to the output transistors would provide more power. Circuit draws about 30 milliamps from a 9 volt supply.

3 Transistor Audio Amp circuit
3 Transistor Audio Amp circuit

Title: 3 Transistor Audio Amp (50 milliwatt)
electronic circuit
Source: unknown
Published on: 2007-07-21
Reads: 2406
Print version: Print version

Other electronic circuits and schematics from Audio

Electronic circuits > Audio > 3 Transistor Audio Amp (50 milliwatt)