Electronic Thermostat and Relay Circuit
Here is a simple thermostat circuit that can be used to control a relay and 
supply power to a small space heater through the relay contacts. The relay 
contacts should be rated above the current requirements for the heater. 
Temperature changes are detected by a (1.7K @ 70F) thermistor placed in series 
with a 5K potentiometer which produces about 50 millivolts per degree F at the 
input of the LM339 voltage comparator. The two 1K resistors connected to pin 7 
set the reference voltage at half the supply voltage and the hysteresis range to 
about 3 degrees or 150 millivolts. The hysteresis range (temperature range where 
the relay engages and disengages) can be adjusted with the 10K resistor between 
pins 1 and 7. A higher value will narrow the range. 
In operation, the series resistor is adjusted so that the relay just toggles off 
at the desired temperature. A three degree drop in temperature should cause the 
relay to toggle back on and remain on until the temperature again rises to the 
preset level. The relay action can be reversed so it toggles off at the lower 
end of the range by reversing the locations of the 5K potentiometer and 
thermistor. The 5.1 volt zener diode regulates the circuit voltage so that small 
changes in the 12 volt supply will not effect operation. The voltage across the 
thermistor should be half the supply or about 2.6 volts when the temperature is 
within the 3 degree range set by the potentiometer. Most any thermistor can be 
used, but the resistance should be above 1K ohm at the temperature of interest. 
The series resistor selected should be about twice the resistance of the 
thermistor so the adjustment ends up near the center of the control. 

Electronic Thermostat and Relay Circuit
        Title: Electronic Thermostat and Relay Circuit
        electronic circuit
        Source: unknown
        Published on: 2007-07-21
        Reads: 2400
        Print version: 
Other electronic circuits and schematics from Test and measurement
-  Voltage follower with 1G ohm input resistance
-  A simple Remote control Tester
-  Continuity Tester
-  Zener Diode Tester
-  Transistor Tester
-  12V Lead-Acid Battery Monitor
-  High Resistance Voltmeter
-  Digital Voltmeter
-  Car Water Temperature
-  Mosfet TESTER
