Sensitive Field Strength Meter
Electronic Schematics > RF circuit > Sensitive Field Strength Meter

Description:
This Field Strength Meter is simple and also quite sensitive. It uses an ordinary digital voltmeter to measure RF signal strength up to a few hundred MHz.

simple fsm

Sensitive Field Strength Meter circuit

Parts List:
1 OA91 Germanium Diode
1 3.3M Resistor
1 100p Capacitor
L1 7 turns on a 1/4 inch former (suitable for around 100MHz)

Notes:
The multimeter should be set to the lowest dc volts range for maximum sensitivity. This is normally 200mV DC for most meters. The circuit works well at VHF (around 100MHz) and was quite pleased with the results. L1 was 7 turns on a quarter inch former with ferrite slug. This covered the UK FM band. A digital multimeter, as opposed to an analogue signal meter offers several advantages in this circuit. First, the impedance of a digital meter is very high, around 10Meg/Volt on most meters. This does not shunt the tank circuit unduly. Second, compared to an analogue meter, very slight differences in signal strength can be more easily observed. Thirdly,a digital meter will have better linearity, responding well to both weak and stronger signals.

Circuit : Andy Collinson
Email: anc@mitedu.freeserve.co.uk

Title: Sensitive Field Strength Meter
electronic circuit
Source: unknown
Published on: 2006-01-15
Reads: 1336
Print version: Print version

Other electronic circuits and schematics from RF circuit

Electronic circuits > RF circuit > Sensitive Field Strength Meter