IR Remote Control Tester
Electronic Schematics > Test and measurement > IR Remote Control Tester

Notes:
I have used a photodiode, SFH2030 as an infra red sensor. A MOSFET opamp, CA3140 is used in the differential mode to amplify the pulses of current from the photodiode. LED1 is an ordinary coloured led which will light when IR radiation is being received. The output of the opamp, pin 6 may be connected to a multimeter set to read DC volts. Infra red remote control strengths can be compared by the meter reading, the higher the reading, the stronger the infra red light. I aimed different remote control at the sensor from about 1 meter away when comparing results. For every microamp of current through the photodiode, about 1 volt is produced at the output. A 741 or LF351 will not work in this circuit.  Although I have used a 12 volt power supply, a 9 volt battery will also work here.

Title: IR Remote Control Tester
electronic circuit
Source: www.electronics-lab.com/
Published on: 2005-02-10
Reads: 957
Print version: Print version

Other electronic circuits and schematics from Test and measurement

Electronic circuits > Test and measurement > IR Remote Control Tester