Cut Phone Line Detector
A while ago I got an email asking for the schematic of a circuit to detect cut phone lines. It didn't take me long to find this circuit in Electronics Now. When the circuit detects that a phone line has been cut, it activates a MOSFET which can be used to drive a relay, motor, etc. It can also be connected to a security system.
Schematic
Parts
| Part | Total Qty. | Description | Substitutions |
| R1, R2, R3 | 3 | 22 Meg 1/4 W Resistor | |
| R4 | 1 | 2.2 Meg 1/4 W Resistor | |
| C1 | 1 | 0.47uF 250V Mylar Capicitor | |
| Q1 | 1 | 2N3904 Transistor | 2N2222 |
| Q2 | 1 | 2N3906 Transistor | |
| Q3 | 1 | IRF510 Power MOSFET | |
| D1 | 1 | 1N914 Diode | |
| Load | 1 | See "Notes" | |
| MISC | 1 | Wire, Phone Connectors, Circiut Board |
Notes
1. The "Load" can be a relay, lamp, motor, etc. The circuit can also be connected to a security system to sound an alarm in case the phone line is cut.
2. If the circuit is connected to a security system or other circuit, both circuits must be electrically isolated from each other using an opto-isolator, relay, etc. This also means that the Cut Phone Line Detector must be powered by a seperate 9V supply.
Title: Cut Phone Line Detector
electronic circuit
Source: www.aaroncake.net/circuits/
Published on: 2005-02-10
Reads: 642
Print version: 
Other electronic circuits and schematics from Telephone related
-
Having secrecy in parallel telephones
-
Telephone Audio Interface
-
Ringing Phone Light Flasher
-
Detector of cellular phone incoming call
-
Phone Broadcaster
-
Telephone Line Vigilant
-
The Link 4+0 – Internal Intercom
-
Two line intercom plus a telephone changeover switch
-
FM Telephone Bug
-
Phone "Hold" With Music